Dead Horse
Platinum Member
I wouldn't give up on that cylinder yet. Have you ever used a vice and sockets to press out U-joints? have you got an air socket big enough? There are a couple techniques that I think can work.
Use some penetrant and some heat. take the fitting off the cylinder and drain it od oil first. Extend the rod out of it to get the seal away fro any heat, also.
You set the press up right it will go, even if you have to use a bit of persuasion........
Good luck.
Use some penetrant and some heat. take the fitting off the cylinder and drain it od oil first. Extend the rod out of it to get the seal away fro any heat, also.
You set the press up right it will go, even if you have to use a bit of persuasion........
Good luck.