CoyPatton
Veteran Member
- Joined
- Aug 10, 2015
- Messages
- 1,482
- Location
- Poplar Bluff, MO
- Tractor
- Yanmar YM2002D with Koyker 110 FEL
So you indicated that when you turn the key you get a click, no motor spinning. You indicate you have replaced the battery, cables and cleaned connections. Make sure all connections are tight. You do not want to break bolts, but none should wiggle even with a very firm tug.
Also consider having that new battery load tested. It is more common than most believe for a new battery to be bad.
Next point is that the starter gets it ground through the mounting bolts of the starter and its contact with the transmission housing. It may be worth-wild to use a ground jumper on one of the starter bolts yo the frame. Use a heavy gauge wire like the negative battery cable for this jumper. Small wires will overheat.
Also consider having that new battery load tested. It is more common than most believe for a new battery to be bad.
Next point is that the starter gets it ground through the mounting bolts of the starter and its contact with the transmission housing. It may be worth-wild to use a ground jumper on one of the starter bolts yo the frame. Use a heavy gauge wire like the negative battery cable for this jumper. Small wires will overheat.