MTGreen
Platinum Member
- Joined
- Oct 12, 2022
- Messages
- 999
- Location
- Montana, USA
- Tractor
- Deere 5220, Ford 1720, Deere Progator 2030
There are at least two dowel pins in the block to bell housing interface as I recall
Anybody ever split a 5520?
- Thread starter fritz423b
- Start date
- Views: 6657
TractorTech
Elite Member
- Joined
- Jan 26, 2012
- Messages
- 2,927
- Location
- California
- Tractor
- Ford 7710, Ford 550, Ford 1910, Ford 4430, KD Forklift, Ford LGT17H, New Holland L255 Skidsteer
Dowel bolts are different than the tractor dowel pins. Dowel bolts are longer bolts than the case bolts and the head is removed. Screw these into the middle bolt holes in the case and this helps line up the input shaft to the pilot bearing. It also aligns the case while you are pushing the to halves together.
Last edited:
Kyle_in_Tex
Super Star Member
How many hours on your machine?
I'll be watching and learning. Thanks for posting pics.
I'll be watching and learning. Thanks for posting pics.
Tx Jim
New Member
Back when I was a JD dealer service manager when splitting tractors we use bolts with heads removed for guides. We rolled rear section from stationary frt section of tractor.
Kyle_in_Tex
Super Star Member
Great progress and great photos! Thanks for sharing.
It looks like you put plugs on some of the hydraulic lines.
Let us know how hard it is to put back together. Hope it goes smoothly.
It looks like you put plugs on some of the hydraulic lines.
Let us know how hard it is to put back together. Hope it goes smoothly.
Kyle_in_Tex
Super Star Member
Oh, and since we have a 5420, I have turbo envy.
Double check your parking pawl for it to be in good shape before you go back together. That is, if you have power reverser tranny.
Double check your parking pawl for it to be in good shape before you go back together. That is, if you have power reverser tranny.
Tx Jim
New Member
Congratulations on split & very nice photos. Will your tractors flywheel tolerate resurfacing? The clutches with metal pads are good clutches but really exert wear on pressure plates & engine flywheels.
Luckily the pto friction disk was good and the flywheel was smooth and flat. I am replacing the pto disk while I'm in there. Guess it makes sense, the traction disk is always in use but the pto disk isn't.
Tx Jim
New Member
Flywheel being smooth surprises me.