Newbie here. Is there anyway to bypass the battery temp sensor on a Ford 555C backhoe? The new alternator will not charge the battery and I was told it needed the sensor which is missing. I would like to bypass it to make sure the alternator is actually still good at least temporarily. Any help would be greatly appreciated.
Battery temp sensor
- Thread starter waveeater
- Start date
- Views: 10088
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,143
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
Buy a 200 ohm resistor and install in the place of the sensor.
Do I just wire it in in the battery box where the sensor goes?
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,143
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
Correct.
I could not find a 200 ohm resistor but I did have a 150 so I put it on and it works; but it痴 charging the battery at 13.75 amps. do you think this will damage the battery?
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,143
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
No. It may undercharge it a bit if anything.
John_Mc
Elite Member
- Joined
- Aug 11, 2001
- Messages
- 4,599
- Location
- Monkton, Vermont
- Tractor
- NH TC33D Modified with belly pan, limb risers & FOPS. Honda Pioneer 520 & antique Coot UTV
Do yu have a 50 ohm you can put in series with the 150 (or two 100 ohm resistors in series)?
