Branson BL20 Quick Connect Bucket to Skidsteer Adapter

Zork · May 29, 2023

So how do you keep the SSQA adapter from popping out?

I put a 3/8 plate at the base which gives me about 60 thousands clearance between the SSQA and the female. My tapered pin is through the female with about 3/4 inch protruding. I put down pressure that was not enough to raise the tires and both of the SSQA adapters popped out from the bottom. The handle didn't release so I presume the tapered pin overcame the spring pressure.

Not good, I can't trust this SSQA connector. Maybe the full tapered pin must protrude to the point past the round rod? I checked online for SSQA failures as previously mentioned, but didnt find much. I might just go back to the Branson/Ansung type mount if there are no satisfactory choices to lock the SSQA in.

Xfaxman · May 30, 2023

Zork said:
The handle didn't release so I presume the tapered pin overcame the spring pressure.

The pin needs to go over center:

And have a stop block to prevent the pin from raising when the handles are down:

Zork · May 30, 2023

Xfaxman said:
The pin needs to go over center:

View attachment 803121

And have a stop block to prevent the pin from raising when the handles are down:

View attachment 803122

My SSQA does not incorporate a stop block for that rod/pin and that is most probably why the pin moved up. Thank you.

Zork · Jul 10, 2023

I installed a stop block and now the pin is positively fixed into the blank tang. Thank you.

Xfaxman · Jul 11, 2023

Zork said:
I installed a stop block and now the pin is positively fixed into the blank tang. Thank you.

Zork · Jul 16, 2023

Well I finally got my grapple running. I like it and I am learning how to use it. It does seem like every other tool has its specific use, I think I will need a clamshell type as now I do see the benefits of the short tines. This grapple does grab a disorderly load of several 10 inch limbs, not pictured.

Zork · Aug 6, 2023

Since installing my locking pin stops, there has been no movement. I painted the pins/stops white for easy viewing that they are locked. The handles position does indicate the locked status but for now I want to see it.

I gave the SSQA a real workout yesterday loading decaying matter from the floor of the woods and lifting the tractor while getting a load. I am feeling more confident about the ssqa system.

Zork · Sep 2, 2023

Zork said:
Since installing my locking pin stops, there has been no movement. I painted the pins/stops white for easy viewing that they are locked. The handles position does indicate the locked status but for now I want to see it.

I gave the SSQA a real workout yesterday loading decaying matter from the floor of the woods and lifting the tractor while getting a load. I am feeling more confident about the ssqa system.

I never included photo of my 3rd/4th function in this thread. I plan on 90's where the straight connectors are.