Creating a Workshop & Home

   / Creating a Workshop & Home
  • Thread Starter
#531  
I cut up the piece I removed into two pieces and put the door back together. I used blocks, glue and staples to hold it together, but wasn't really happy with how that was working. Next I drilled some holes in the back and put a little expanding foam in along all the seams and clamped it tight. I did this on the outside too.

The next day when everything was dry, it was quite solid.

After this picture was taken, I cleaned it up and sanded sanded it smooth. Since I wanted the fake wood grain, I went over the sanded areas with my dremel.

Eddie
 

Attachments

  • 830468-100_4252 (Small).JPG
    830468-100_4252 (Small).JPG
    26.3 KB · Views: 944
   / Creating a Workshop & Home
  • Thread Starter
#532  
One suprise that I wasn't expecting what the top inside edge of the door catching on the top of the frame. I had to cut it down to a point and bevel the edge half way up. Now it opens and closes just like it should.

I'll paint the door when I buy the trim. Otherwise, it's done.

Eddie
 

Attachments

  • 830470-100_4254 (Small).JPG
    830470-100_4254 (Small).JPG
    14.6 KB · Views: 893
   / Creating a Workshop & Home #533  
Eddie, you are a genius. Who else wouldda thunk up a solution like that? Pure genius.
 
   / Creating a Workshop & Home
  • Thread Starter
#535  
bones,

Thank you.

Eddie
 

Tractor & Equipment Auctions

2005 Isuzu FTR Truck, VIN # 4GTJ7F1365F700278 (A48836)
2005 Isuzu FTR...
2011 John Deere 844K Articulated Wheel Loader (A50322)
2011 John Deere...
Brown 417 7ft Rotary Cutter (A50490)
Brown 417 7ft...
2019 Allmand Light tower (A49461)
2019 Allmand Light...
FURUKAWA FD45P CRAWLER DOZER (A50458)
FURUKAWA FD45P...
2009 Leistritz L2NT-106/150 Vertical Turbine Pump (A49346)
2009 Leistritz...
 
Top