I'm about 6' and have to have my suspension seat raised all the way on my CX. As such the loader valve control arm is about 4-6" shy of where I naturally grab for it.
Does the knob just twist off, or are they a friction fit? No set screw that I could see. Gave it a good twist, but because I wasn't vice gripping the lever itself didn't want to spin something beneath the boot. I'm thinking because it's sort of rubbery I may need to pry it off. Wanna see what I can do to lengthen it.
Also somewhat related there's about 3/4" slop all around on the control. This is cable piloted. Any way to tighten this up, or better I just leave it and not risk it drifting/not return to center?
Thanks in advance.
Does the knob just twist off, or are they a friction fit? No set screw that I could see. Gave it a good twist, but because I wasn't vice gripping the lever itself didn't want to spin something beneath the boot. I'm thinking because it's sort of rubbery I may need to pry it off. Wanna see what I can do to lengthen it.
Also somewhat related there's about 3/4" slop all around on the control. This is cable piloted. Any way to tighten this up, or better I just leave it and not risk it drifting/not return to center?
Thanks in advance.