Drawbar question

[LostnTractorlnd]

Hello! I am looking at buying my first tractor, and confused by some of the terminology I have run across. I think I am doing pretty well figuring stuff out, but I am confused by the term "drawbar" . I know it may be basic to most of y'all here, but I want to understand what I am spending my fortune on.

So, what is a drawbar, and what are some of the uses of same?

I have to tell ya, the knowledge level of the users on this board is incredible. I was a member of some other boards trying to gather information, and was disappointed with both the knowledge level and activity level of those boards. This is obviously the place to be!

 

[DUMBDOG]

The drawbar is the hitch to the tractor. It would be used to pull attachments behind the tractor that do not hook up to the three point hitch system. An example of of use would be a trailer. It is the best place to hook up a chain or cable to pull out some one who is stuck or for pulling stumps.

 

[NY_Yankees_Fan]

On the attached picture you will see a weight box on the back of the BX. It is sitting on the draw bar. Hope this helps.

 

[ronjhall]

Attached is a picture of the drawbar as most manufactures refer to in their manuals. Red circle is drawbar.

 

[Bird]

The one Tom has his weight box sitting on (between the two lower link arms) is commonly called a "drawbar" and the one sticking out from the bottom of the tractor differential is commonly called a "swinging drawbar". Of course on many of the smaller tractors, you can't actually swing it off to one side, as you can on many of the bigger tractors.

 

[BB_TX]

Some implements are designed to be pulled by a tractor, as opposed to a 3 pt type implement that is held on the 3 point hitch. There is a large flat steel bar with a hole in it out the back of the tractor just below the rear differential. You can put a ball hitch to pull a trailer, a clevis hitch to hook a chain to, or just drop a pin thru for pulling something like a hay baler. You will see tractors hp ratings as engine hp, pto hp, and drawbar hp, all of which will be slightly different. Drawbar hp is basically the pulling hp.

 

[ronjhall]

Here is a scan of my B2910 manual showing the drawbar.

 

[Bird]

Yep, Ron, I said "commonly". It gets confusing because there are two drawbars. Tractor Supply Company used to have their Blue Book on the Internet that included a sketch like your manual has and labelled the two different drawbars as I mentioned. I think if you went to your Kubota dealer and asked for a drawbar, they'd have to ask you which one you meant.

 

[KiotiJohn]

As the others have already explained what it is, I'd like to say something about why it's what you need to pull from.
Pulling a tree, stump etc. from any higher up than the drawbar can cause the tractor to roll over backwards.
The drawbar is placed strategically to be in the proper spot so that the fulcrum of the rear tires is not activated. Pull up higher, and the front swings back and over the rear tires, and usually quite quickly.
While I don't always hook TO the drawbar for pulling, I always try to hook at the same level (I sometimes hook to a boom pole) so that I have no rollover concerns. John

 

[JerryG]

<font color="blue"> I always try to hook at the same level (I sometimes hook to a boom pole) so that I have no rollover concerns. </font>
Why would you not have any concern about rollover when using a boom pole?