Hey guys just got my head resurfaced on a long 460 and now my push rods are too long. Any advice? I've heard of this happening before but never experienced it personally and it's VERY time sensitive to getting it back running thanks.
HELP!!
- Thread starter klc336
- Start date
- Views: 2225
Rockbadchild
Elite Member
thick head gasket / head gasket spacer or shim
M59
Gold Member
- Joined
- Oct 27, 2014
- Messages
- 491
- Location
- Fairview NC
- Tractor
- Kubota M59 TLB/ Mahindra Max 24 TLB/ KX-080-5
How much taken off the head?
How much too long are push rods?
How much too long are push rods?
pycoed
Silver Member
- Joined
- Mar 28, 2007
- Messages
- 173
- Location
- West Wales UK
- Tractor
- Zetor 7045; Wheelhorses C121, C101, A8;Cushman Turf truckster
Rather than disturb the head again, just fit spacers under the rocker towers?
Tx Jim
New Member
I wonder if valve were recessed in cylinder head too deep causing valve stems to protyrude to far out of head which in turn would cause pushrods to be too long.
Tx Jim
New Member
Thicker than specification head gasket will lower engine compression ratio causing engine to be more difficult to start operating.
Honestly not sure how much was taken off. But hmm. I might could make some 1/4" shims. Previously I had full range of adjustment and now the rockers are adjusted all the way out and still need more. I would think a 1/4 inch shim on each tower should be plenty. Surely they didn't remove more than that.
Rockbadchild
Elite Member
they wouldn't take that much ... something is not right ...
Rockbadchild
Elite Member
I know but if you take some out and you put back what they taken off with a gasket then you end up at the same point you started from.
Rockbadchild
Elite Member
have you move your crank ? was it at zero when you took the head off and is it still at zero ?