Hour meter install

[AHNC]

My 2660 dash conked out so I have lost hour meter and rpm. They want about $450 for a new dash and while I love the machine I think I will just install an hour meter to keep up with service times. Fuel gauge is unreliable, but temp gauge works...for now! Much obliged for any alternatives/recommendations you can suggest. What am I missing?
My BX23 has the analog hour meter. Electronics are great, but...!

 

[diesel85]

Hobbs Quartz Hourmeters are "the" standard.

https://www.amazon.com/Honeywell-Ho...t=&hvlocphy=9005284&hvtargid=pla-593588530514

Cheap!

Just tie it into something that is only KOEO or preferably KOER.

 

[Roadworthy]

Are you sure the demise of your dash killed your tach and hour meter? On many tractors (even some newer ones) the tach drives off a cable from the engine or alternator. Check to make sure you haven't just lost the cable. It's like the old speedometer cables - same principle.

 

[AHNC]

Actually, Roadworthy, no I am not. I just cannot read the digital display which indicated to me that it is shot. Any suggestions? Perhaps I can just replace the display? I will check and see if it is offered as a part.

 

[ptsg]

Maybe you can get it repaired? Some companies are able to repair dashes.

 

[sandyc]

I had an old bx2200 that had no tack. I added a small tack that tied to the number one injector pipe. If memory serves, the cost was minimal. That plus an hour meter might keep your costs down.
Sorry I don’t remember cost or where I got it.

 

[AHNC]

I will look into this a bit further. The "brains" of the unit must be a chip somewhere and the problem is likely...hopefully, the segmented display. Now to find the same size display. I am out of my league on this, but...onward through the fog!