AndyM
Veteran Member
- Joined
- Jul 4, 2003
- Messages
- 2,369
- Location
- NW PA, USA
- Tractor
- 1948 Ford 8N and 1993 Toro WheelHorse 520H
Soundguy said:
I always thought a palnut was one of those little tophats...
I knew it!
- Thread starter daTeacha
- Start date
- Views: 3062
I always thought a palnut was one of those little tophats...
two things..
1) will someone PM me about what I missed? I need a good laugh today.
2) I would use the Blue Loctite. NOt KNowing if you want this to be permanent or not.... Red is considered the permanent loctite. VERY hard to get apart. We use Blue Loctite in our Backhoe mount kits.
1) will someone PM me about what I missed? I need a good laugh today.
2) I would use the Blue Loctite. NOt KNowing if you want this to be permanent or not.... Red is considered the permanent loctite. VERY hard to get apart. We use Blue Loctite in our Backhoe mount kits.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
AndyM said:I always thought a palnut was one of those little tophats...
Yes.. I think those qualify, as well as many other kinds of 'push' nuts. I've seen them used as retainers and whatnot.. but after thinking about his application.. a jambnut would be superior.. etc.
soundguy
OP
daTeacha
Veteran Member
Personally, I would just use two of the internally threaded friction based fastening devices on each side, tightening the outermost against the innermost to prevent either from turning. You could also put a simple split or star type lock washer between the members of each pair. The internally threaded friction based fastening devices are tightened with a device known as a wrench.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Why buy a locknut to add to the regular nut.. when a jambnut will be cheaper and accomplish the same thing? ( 2 nuts tightened slightly against each other... ) Heck.. add a drop of the green loctite afterwards... kill the vibration problems..
Soundguy
Soundguy