If you have Toolcat questions, ask them here...

   / If you have Toolcat questions, ask them here... #701  
Use a slide hammer type seal puller like this one. Drill a small hole in the seal and screw in a metal screw. Use the SH attachment that hooks under the screw head (second from right) and carefully pull the seal.

Slide Hammer and Puller Set, 14 Piece
 
   / If you have Toolcat questions, ask them here... #702  
Thank you ruffdog, i'll let you know how it turns out.
 
   / If you have Toolcat questions, ask them here... #703  
in the past I have used a self drill screw to thread into the seal, usually 2 opposite or 3 evenly spaced and used a pry bar to ease it out, seems on older machines the seals were way better, these new ones are tin and wear faster
 
   / If you have Toolcat questions, ask them here... #704  
How do I clear the service reminder on my 2021 Toolcat (with a keyless start).

I cannot find instructions how to do it in the service manual.

Are these instructions correct for my machine?
 
   / If you have Toolcat questions, ask them here... #705  
My service manual for my 2017 G series 5610 (section 60-190 Maintenance clock) agrees with the post above with minor changes:

Key OFF (press OFF for keyless), Press the HOURS button to turn the panel ON, Press and hold both HOURS and AUX HYDRAULICS till panel displays reset.
 
Last edited:
   / If you have Toolcat questions, ask them here... #706  
Thanks. I’ll try to use your page reference to find it my manual as well.
 
   / If you have Toolcat questions, ask them here... #707  
Have a 2007 with 2 codes:
50-73
50-75

Anyone have a code list?
 
   / If you have Toolcat questions, ask them here... #708  
Just replaced the controller on a 5600 Toolcat and now the glow plug and aux hydraulics lights are flashing, the temp gauge is pinned to max...

It starts ok, but won't go into gear or anything else. Lift tilt and traction functions disabled even with arm rest down.

What's going on? Is there a reset procedure for a new controller?

Any help appreciated!!
 
   / If you have Toolcat questions, ask them here... #709  
Just replaced the controller on a 5600 Toolcat and now the glow plug and aux hydraulics lights are flashing, the temp gauge is pinned to max...

It starts ok, but won't go into gear or anything else. Lift tilt and traction functions disabled even with arm rest down.

What's going on? Is there a reset procedure for a new controller?

Any help appreciated!!
What was the reason for the new controller? Does it have keyless start? Did you double check the connections for loose,broken,bent pins?
 
   / If you have Toolcat questions, ask them here... #710  
Have a 2007 with 2 codes:
50-73
50-75

Anyone have a code list?

50-73 = Throttle Sensor Ch A Out Of Range High
50-75 = Throttle Sensor Ch B Out Of Range High
 

Tractor & Equipment Auctions

8' Container (A36337)
8' Container (A36337)
Shop Built Flatbed Trailer (A36337)
Shop Built Flatbed...
2019 Freightliner M2 106 Crew Cab Service Truck (A35915)
2019 Freightliner...
2024 Golden Mountain 20ft x 30ft x 12ft Storage Shelter (New/Unused) (A35780)
2024 Golden...
Case 550H Crawler Dozer (A36337)
Case 550H Crawler...
2013 New Holland 880CF-35 (A35780)
2013 New Holland...
 
Top