Installing a small FEL on Kubota tractor

[zman007007]

I bought that box scrape from a guy down the road a few miles from me for $125.00 it looked like it had taken a tumble off a trailer, but with the help of the old rosebud and a sledge hammer I got it straighten enough to use, and it works alot better than the scrape blade on my gravel road.

 

[zman007007]

Last ones I promise, lol . I also have a 48" tiller with it, but I am having a hard time finding the upper part of the pto for it. It is a FL 1000 model. I have the lower part with the slip clutch. 3 dealers tell me that part, is no longer available and I have to buy the whole drive shaft. Oh well. The last 2 photos are of a Ariens GT-14, I am restoring. I added the dual rear wheels and also all the rear wheels are orange pin striped. It also is fully hydraulic, front, mid, and rear and is a pretty good little horse for a gas engine. Its been put on the rear burner since I got the Kubota.

 

[jas67]

Zman -- PLEASE get some proper hydraulic fittings for your high-pressure hydraulic connections. Those galvanized iron pipe fittings (the 45degree, and 90degree street elbow) on your hydraulic block are only rated for like 150 PSI.

https://www.surpluscenter.com/item.asp?UID=2009080321435083&item=9-1503-6-6&catname=hydraulic

https://www.surpluscenter.com/item.asp?UID=2009080321435083&item=9-1501-6-6&catname=hydraulic

 

[zman007007]

alright jas67 I will do that thanks