international TD 6

[Hookblock]

I was wondering if anybody had away to id a TD 6. The tag by the foot brake pedal is gone. Thanks

 

[Ken]

Any idea of age? A TD9 mid '40's the serial # was stamped upper left side of dash.This was the only ID I knew about.

If gas/Diesel conversion engine hope you never have to hand crank.

ken

 

[Hookblock]

Ken, not Shur of the year, it is a gas/ diesel. Been sitting for years, just got it to run on gas. Was going to look into a service Manuel for it.

 

[art]

The engine and much of the drives are the same as the old MD, WD-6 farm tractors.

 

[Ken]

Ken, not Shur of the year, it is a gas/ diesel. Been sitting for years, just got it to run on gas. Was going to look into a service Manuel for it.

Hookblock have a manuel for the TD9 and part # may be different but the whole concept is the same. engine adjustments and when to adjust.
Printed in 1944 and used into the 70's never really looked at the dozer size. Not like today where every tractor # has special parts.
Send a pm of address will mail to you. I will never use again.
ken

 

[Hookblock]

Thanks Ken, sent you a pm

 

[Ken]

Hookblock Was up Hwy 39 toward Baraboo/Dekora and the Wisconsin Dells this spring.
Then next week going to Rockford/Belvidere Ill guess not far from your location. Book will be mailed tomorrow should be at your address by end of week. enjoy.
Is this dozer for work or yard ornament?
ken

 

[Hookblock]

Ken, Thanks again. I plan on using it for small projects around the house and up in the woods. I like it because it is portable for me. As a plus it also has a pto, now looking it finding a tph for it so I can use it more.

 

[Hookblock]

Got some pics, and my first dirt

 

[Ken]

Hookblock Good pictures and the tractor looks hardly been used. Also the method of raising the blade is standred. Really it is a good looking dozer for the age.
Trust the book will help in getting repaired and enjoy the use of it.
Headed for Belvidere Ill. in the morning going to the fair grounds Holstein cattle show.

ken

 

[Tex5String]

Your pics look great! Congratulations!

Take a look at the RedPower forum for ConstructionEquip/Crawlers. There used to be a couple of regulars who talked about running their TD's daily.

Red Power Magazine Community (Powered by Invision Power Board)

 

[farmerdave001]

I tried to post the TD6 manuel that I have but the file is to big to post any suggestions how to post?

 

[Foxtrot08]

Looks like the Drott blade package on it? Mine has the BE.

The T6 series is an amazing piece. Ours still runs great, engine parts are pretty easy to source - same as a farmall M normally.