Buying Advice JD 4300 questions

   / JD 4300 questions
  • Thread Starter
#11  
I found the oil almost in the center of the tractor underneath where the floorboard would be located.
 
   / JD 4300 questions #12  
That could be a loose filter or suction screen mount and clamp. But if you have doubts, keep searching.
 
   / JD 4300 questions
  • Thread Starter
#13  
I spoke to the dealer that has this tractor and he has had it looked at since I pointed the leak out to him. The report is that the leak was coming from a "plate" underneath the tractor and they have had it fixed.

Any ideas what this could mean?
 
   / JD 4300 questions #14  
Part #9 maybe?
 

Attachments

  • MP40402________UN02NOV07.gif
    MP40402________UN02NOV07.gif
    30.8 KB · Views: 184
   / JD 4300 questions
  • Thread Starter
#15  
arabil. you were correct. It was the part that you indicated. They replaced the gasket.

Thanks to everyone for their help and answers!

I am now the owner of a John Deere 4300!!! It is being delivered Friday.

Would the dealer be the best place to get an operators manual or should I buy it online somewhere?
 
   / JD 4300 questions #16  
Hmmm. While I like to be correct and all, plate #9 doesn't have a gasket. Did they mean a liquid gasket/sealant? Cause if not, then it couldn't have been what I said.... :)
 
   / JD 4300 questions #17  
Hmmm. While I like to be correct and all, plate #9 doesn't have a gasket. Did they mean a liquid gasket/sealant? Cause if not, then it couldn't have been what I said.... :)

That plate might be a little warped...necessitating a gasket of some sort.
 
   / JD 4300 questions #18  
arabil. you were correct. It was the part that you indicated. They replaced the gasket.

Thanks to everyone for their help and answers!

I am now the owner of a John Deere 4300!!! It is being delivered Friday.

Would the dealer be the best place to get an operators manual or should I buy it online somewhere?

Congrats! Why buy it when it's free:thumbsup: Click the link below

Introduction
 
   / JD 4300 questions #19  
necessitating a gasket of some sort.
It had to be sealed to the housing no matter what if it was to hold fluid in. I rarely hear sealant referred to as a gasket is all.
 
   / JD 4300 questions
  • Thread Starter
#20  
Thanks for the link.

I guess "gasket" may have been my slip. The dealer did say that they used sealant.
 

Tractor & Equipment Auctions

Killbros 260 Seed Conveyor (A53472)
Killbros 260 Seed...
J BAR SD5 5' ROTARY MOWER (A51247)
J BAR SD5 5'...
2018 Infiniti Q50 AWD Sedan (A51694)
2018 Infiniti Q50...
2020 JOHN DEERE 5125R LOT IDENTIFIER 24 (A53084)
2020 JOHN DEERE...
2006 Reelmaster Toro 3100D Mower (A50324)
2006 Reelmaster...
2020 CASE IH 110N LOT IDENTIFIER 207 (A53084)
2020 CASE IH 110N...
 
Top