Buying Advice JD 4300 questions

   / JD 4300 questions
  • Thread Starter
#11  
I found the oil almost in the center of the tractor underneath where the floorboard would be located.
 
   / JD 4300 questions #12  
That could be a loose filter or suction screen mount and clamp. But if you have doubts, keep searching.
 
   / JD 4300 questions
  • Thread Starter
#13  
I spoke to the dealer that has this tractor and he has had it looked at since I pointed the leak out to him. The report is that the leak was coming from a "plate" underneath the tractor and they have had it fixed.

Any ideas what this could mean?
 
   / JD 4300 questions #14  
Part #9 maybe?
 

Attachments

  • MP40402________UN02NOV07.gif
    MP40402________UN02NOV07.gif
    30.8 KB · Views: 184
   / JD 4300 questions
  • Thread Starter
#15  
arabil. you were correct. It was the part that you indicated. They replaced the gasket.

Thanks to everyone for their help and answers!

I am now the owner of a John Deere 4300!!! It is being delivered Friday.

Would the dealer be the best place to get an operators manual or should I buy it online somewhere?
 
   / JD 4300 questions #16  
Hmmm. While I like to be correct and all, plate #9 doesn't have a gasket. Did they mean a liquid gasket/sealant? Cause if not, then it couldn't have been what I said.... :)
 
   / JD 4300 questions #17  
Hmmm. While I like to be correct and all, plate #9 doesn't have a gasket. Did they mean a liquid gasket/sealant? Cause if not, then it couldn't have been what I said.... :)

That plate might be a little warped...necessitating a gasket of some sort.
 
   / JD 4300 questions #18  
arabil. you were correct. It was the part that you indicated. They replaced the gasket.

Thanks to everyone for their help and answers!

I am now the owner of a John Deere 4300!!! It is being delivered Friday.

Would the dealer be the best place to get an operators manual or should I buy it online somewhere?

Congrats! Why buy it when it's free:thumbsup: Click the link below

Introduction
 
   / JD 4300 questions #19  
necessitating a gasket of some sort.
It had to be sealed to the housing no matter what if it was to hold fluid in. I rarely hear sealant referred to as a gasket is all.
 
   / JD 4300 questions
  • Thread Starter
#20  
Thanks for the link.

I guess "gasket" may have been my slip. The dealer did say that they used sealant.
 

Tractor & Equipment Auctions

2020 JOHN DEERE 7R210 LOT IDENTIFIER 46 (A53084)
2020 JOHN DEERE...
2016 Crane Carrier Co. Low Entry New Way 31ASL 31Yd Side Loader Garbage Truck (A51692)
2016 Crane Carrier...
2020 JOHN DEERE 333G SKID STEER (A51246)
2020 JOHN DEERE...
2020 COLOMBO TM LOT IDENTIFIER 200 (A53084)
2020 COLOMBO TM...
UNUSED AGT ATK-TC24 TIRE CHANGER (A51248)
UNUSED AGT...
1989 Ford FT900 T/A Cab and Chassis Truck (A51692)
1989 Ford FT900...
 
Top