jjeff
Elite Member
Yeah I need luck with this one, I was running 025 mig wire then 030 fc, before hand always does the same darn sputtering thing will check liner again if it's short crimped or short, didn't appear to be though if I looked at it right. I've changed out feed rollers and blocks to the specific wire I was using everytime.Flux core needs to be Straight Polarity or electrode negative. Also if the liner is cut to the wrong length or is getting used up you can cause it to sputter just by over bending your wrist. That can happen if the feed rolls are too loose as well. I like an oversized liner too. If you are running 035 FC, see if they have an 045 liner. Good luck