L3200 SSQA bucket measurement needed

[k0ua]

seems like you welded the plate awful high, how did you come up with your figuring on the mount? I saw another picture from someone else and theres looked too low but I have no point of reference as I never seen a real SSQA on a l3200

All I can say is it works well. I had a factory SSQA bucket too..Of course I don't have it any more. I still have the bucket I moded.. I use it all the time for my "beater bucket". Let me see If I can find a pix of the factory bucket... I don't know if you can blow this up enough to do any good or not, plus the light was failing.

 

[rwurbanwildlife]

Hope I am not being a PIA but you got a sideways view of the tractor you did with the SSQA bucket on?

 

[k0ua]

Looks to me the factory bucket is pretty close to what I built..height wise

 

[rwurbanwildlife]

funny I think u posted the picture the same time I was asking if you had one.

 

[k0ua]

funny I think u posted the picture the same time I was asking if you had one.

Yup. are you good now?

 

[rwurbanwildlife]

I think so, looks like the top of your plate is about an inch above the roll in the bucket. Guess I will weld it tomorrow, thanks!

 

[rwurbanwildlife]

did you install a 3rd function on your hydraulics? If so where you get yours from?

 

[k0ua]

I think so, looks like the top of your plate is about an inch above the roll in the bucket. Guess I will weld it tomorrow, thanks!

Good luck, you have the hard part (the bucket stipped of the ears) done,, the welding is almost fun..

 

[k0ua]

did you install a 3rd function on your hydraulics? If so where you get yours from?

Well I just used the rear remotes.. here is the thread.

http://www.tractorbynet.com/forums/hydraulics/284901-hydraulic-quick-connects-loader-torque.html

 

[k0ua]

I lengthened the control stick for the rear remote, to make it a little easier to reach.. I don't know if you have any rear remotes or not though.. You might want to go electric over hydraulic.

http://www.tractorbynet.com/forums/...896-making-extension-control-valve-lever.html