My bucket sucks!

   / My bucket sucks! #31  
Let me rephrase:

Bucket for bucket, the Foundry bucket has more reinforcement for heavier duty use.
 
   / My bucket sucks! #32  
KennedyDiesel said:
Let me rephrase:

Bucket for bucket, the Foundry bucket has more reinforcement for heavier duty use.

So this bucket " Worksite Pro # KV11636" requires additional mounting hardware?
 
   / My bucket sucks! #33  
I think the 300CX is built a bit heavier isn't it?
 
   / My bucket sucks! #34  
After revieiwng all the messages in this thread, I am gonna look at what it would cost to get one of those workforce buckets instead of the 61" or 73" materials buckets
 
   / My bucket sucks! #35  
KennedyDiesel said:
Let me rephrase:

Bucket for bucket, the Foundry bucket has more reinforcement for heavier duty use.

Gotcha. I was reading your post literally rather than how you intended. Yeah, I don't use my bucket for tearing out old concrete and stuff like that. If I did, I foundry bucket would make more sense. I do gravel, rip rap and stuff like that at times without any issue. I have rip rap (is that what the stuff is really called?) around my lake and it's easier on my back to place it with my loader than by hand. :)

Nuru, if you have the 'quick attach' bucket on your loader it's nothing to change buckets and no mounting hardware would be needed. I can change between a spear, pallet forks, and my bucket in literally just a couple minutes each. If I had a way of seeing the front plates on the loader mount, I could likely do it faster.
 
   / My bucket sucks! #36  
Dargo said:
Gotcha. I was reading your post literally rather than how you intended. Yeah, I don't use my bucket for tearing out old concrete and stuff like that. If I did, I foundry bucket would make more sense. I do gravel, rip rap and stuff like that at times without any issue. I have rip rap (is that what the stuff is really called?) around my lake and it's easier on my back to place it with my loader than by hand. :)

Nuru, if you have the 'quick attach' bucket on your loader it's nothing to change buckets and no mounting hardware would be needed. I can change between a spear, pallet forks, and my bucket in literally just a couple minutes each. If I had a way of seeing the front plates on the loader mount, I could likely do it faster.

On the 300Cx, the bucket comes off in seconds, just two pins and that is really it. So i think i am golden.
 

Tractor & Equipment Auctions

(4) 8 LUG WHEELS (A54756)
(4) 8 LUG WHEELS...
SDLanch SDLD25 (A53316)
SDLanch SDLD25...
JOHN DEERE 7210R TRACTOR (A51247)
JOHN DEERE 7210R...
2009 Ford F-350 4x4 Flatbed Truck (A51692)
2009 Ford F-350...
2024 KMC 7406 (A53084)
2024 KMC 7406 (A53084)
2017 CHALLENGER MT465E TRACTOR (A51406)
2017 CHALLENGER...
 
Top