My bucket sucks!

   / My bucket sucks! #31  
Let me rephrase:

Bucket for bucket, the Foundry bucket has more reinforcement for heavier duty use.
 
   / My bucket sucks! #32  
KennedyDiesel said:
Let me rephrase:

Bucket for bucket, the Foundry bucket has more reinforcement for heavier duty use.

So this bucket " Worksite Pro # KV11636" requires additional mounting hardware?
 
   / My bucket sucks! #33  
I think the 300CX is built a bit heavier isn't it?
 
   / My bucket sucks! #34  
After revieiwng all the messages in this thread, I am gonna look at what it would cost to get one of those workforce buckets instead of the 61" or 73" materials buckets
 
   / My bucket sucks! #35  
KennedyDiesel said:
Let me rephrase:

Bucket for bucket, the Foundry bucket has more reinforcement for heavier duty use.

Gotcha. I was reading your post literally rather than how you intended. Yeah, I don't use my bucket for tearing out old concrete and stuff like that. If I did, I foundry bucket would make more sense. I do gravel, rip rap and stuff like that at times without any issue. I have rip rap (is that what the stuff is really called?) around my lake and it's easier on my back to place it with my loader than by hand. :)

Nuru, if you have the 'quick attach' bucket on your loader it's nothing to change buckets and no mounting hardware would be needed. I can change between a spear, pallet forks, and my bucket in literally just a couple minutes each. If I had a way of seeing the front plates on the loader mount, I could likely do it faster.
 
   / My bucket sucks! #36  
Dargo said:
Gotcha. I was reading your post literally rather than how you intended. Yeah, I don't use my bucket for tearing out old concrete and stuff like that. If I did, I foundry bucket would make more sense. I do gravel, rip rap and stuff like that at times without any issue. I have rip rap (is that what the stuff is really called?) around my lake and it's easier on my back to place it with my loader than by hand. :)

Nuru, if you have the 'quick attach' bucket on your loader it's nothing to change buckets and no mounting hardware would be needed. I can change between a spear, pallet forks, and my bucket in literally just a couple minutes each. If I had a way of seeing the front plates on the loader mount, I could likely do it faster.

On the 300Cx, the bucket comes off in seconds, just two pins and that is really it. So i think i am golden.
 

Tractor & Equipment Auctions

MINI KID DIRT BIKE (A56859)
MINI KID DIRT BIKE...
2013 Grove TMS 9000E 110 Ton Hydraulic Truck Crane (A60460)
2013 Grove TMS...
John Deere 4-Bottom Plow (A56438)
John Deere...
2020 CATERPILLAR CB13 SMOOTH DBL DRUM ROLLER (A60429)
2020 CATERPILLAR...
2012 VOLVO A40F OFF ROAD DUMP TRUCK (A60429)
2012 VOLVO A40F...
48ft all aluminum feather light wedge trailer (A56438)
48ft all aluminum...
 
Top