Oil & Fuel need advice

   / need advice #12  
Did they clean the strainer too? Would've been a great time to do that with a new spin on filter. Just saying. I doubt it hurt anything either.
 
   / need advice #13  
I would say the hydraulic pump is the first thing that gets hit in such a situation. I wouldn't be worried about any other parts.
 
   / need advice #14  
I think the lubricated parts probably had enough oil stuck to them to prevent any significant damage.
Did you get a transmission low fluid light, warning, or buzzer?

Did anything feel overly hot? Any burning smell? (Not my wifes cooking, your tractor) :laughing:
 
   / need advice
  • Thread Starter
#15  
have barley used the tractor, the plug coming completely out after a few hours on it was a factory issue, not my fault and yes they replaced screen and filter. hydraulic pump was my worry too but no low oil lights just a slight burning smell
 
   / need advice #16  
The question is why, who and where was the plug left unsecure. Just saying.
 
   / need advice #17  
Apparently no one knows why and it was by someone in the chain that built or sold it at some factory or dealer location. You know, incompetence is everywhere.
 

Tractor & Equipment Auctions

UNUSED FUTURE FT-13 EXCAVATOR (A54756)
UNUSED FUTURE...
NEW HOLLAND TS6.120 TRACTOR (A51406)
NEW HOLLAND...
2006 CHEVROLET SILVERADO 4X4 PICKUP TRUCK (A51222)
2006 CHEVROLET...
JLG 1255 Telehandler (A55218)
JLG 1255...
2016 Kia Optima Sedan (A48082)
2016 Kia Optima...
48" WIDE WOODEN STAIRCASE W/ METAL RAILING (A54757)
48" WIDE WOODEN...
 
Top