Oil & Fuel need advice

   / need advice #12  
Did they clean the strainer too? Would've been a great time to do that with a new spin on filter. Just saying. I doubt it hurt anything either.
 
   / need advice #13  
I would say the hydraulic pump is the first thing that gets hit in such a situation. I wouldn't be worried about any other parts.
 
   / need advice #14  
I think the lubricated parts probably had enough oil stuck to them to prevent any significant damage.
Did you get a transmission low fluid light, warning, or buzzer?

Did anything feel overly hot? Any burning smell? (Not my wifes cooking, your tractor) :laughing:
 
   / need advice
  • Thread Starter
#15  
have barley used the tractor, the plug coming completely out after a few hours on it was a factory issue, not my fault and yes they replaced screen and filter. hydraulic pump was my worry too but no low oil lights just a slight burning smell
 
   / need advice #16  
The question is why, who and where was the plug left unsecure. Just saying.
 
   / need advice #17  
Apparently no one knows why and it was by someone in the chain that built or sold it at some factory or dealer location. You know, incompetence is everywhere.
 

Tractor & Equipment Auctions

2013 Ford F-550 4x4 Ext. Cab Service Truck (A55788)
2013 Ford F-550...
2005 Ford F-350 4x4 Dually Truck, VIN # 1FTWW33P35EC55643 (A54865)
2005 Ford F-350...
2020 INTERNATIONAL LT625 SLEEPER TRUCK (A54607)
2020 INTERNATIONAL...
UNUSED WOLVERINE PFA-11-3300G HYD PALLET FORKS (A54757)
UNUSED WOLVERINE...
2004 Ford F-250 Liftmoore 2,700 LB 1 Ton Crane Service Truck (A53422)
2004 Ford F-250...
2008 KALMER 4X2 SPOTTER TRUCK (A51247)
2008 KALMER 4X2...
 
Top