Hi, so my pump does not have those witnesses marks at the end but it does have one next to the post and a line down the middle that i can't get to meet the mark. Here are some photos.
No it's the top of the pump. I took the pump out to get a better look and the mark i thought was something turned out to be a speck if dirt. Attached are photos of the pump take out. You can see the shaft has two marks on the rod but i can't make out any other marks to base off of.
so the part K does not appear to be bent. Is there a different mark on the one for the Japanese side that is to base where the rod should be in relation to the body for governor K link? I think once I figure out where it needs to be it will be easy to get the rest of the parts moving so to speak.
so the part K does not appear to be bent. Is there a different mark on the one for the Japanese side that is to base where the rod should be in relation to the body for governor K link? I think once I figure out where it needs to be it will be easy to get the rest of the parts moving so to speak.
so the cover that you would have to remove is the one above the fuel pump connected to the crank case vent. I am trying to find more info on this pump as well but no dice.I'll have to snap the pix tomorrow. To dark outside now.