That would require tools from the 1st drawer....
No No...
Screwdrivers should flat blades with handles along front of drawer. Phillips handles along back of drawer. Arranged from large to small.
Quirky and OCD tendencies..... Anyone else have them?
- Thread starter Pixguy
- Start date
- Views: 30099
No No...
Screwdrivers should flat blades with handles along front of drawer. Phillips handles along back of drawer. Arranged from large to small.
goeduck
Super Member
Sounds kinda screwy to me
prichard
Veteran Member
This whole thread is screwy. What's your point?Sounds kinda screwy to me
OP
Pixguy
Elite Member
This whole thread is screwy. What's your point?
Hey.... I resemble that remark! :laughing:
PILOON
Super Star Member
Screw U, LOL
Ken
Veteran Member
4570 Do you pour from 5 gal bucket with the hole up or down. Down will suck in air and cause the paint splatter. up the paint will run out but across the top if not careful.
ken
4570Man
Super Star Member
- Joined
- Apr 7, 2015
- Messages
- 18,335
- Location
- Crossville, TN
- Tractor
- Kubota M59, Kubota L3800, Grasshopper 428D, Topkick dump truck, 3500 dump truck, 10 ton trailer, more lighter trailers.
I pour the metal cans of paint thinner and quart oil bottles with the hole on the top side. I pour the 5 gallon cans hole down. I usually lay the bucket on it’s side with the paint tray under it and compress the bucket with my knee. I could see how pouring it spout up could work too though.
Ken
Veteran Member
l learned this trying to pour Hydraulic fluid into the off set fill hole of John Deere tractor. pointing at the roll over bar bolting location under the cross bar holding the seat. Some where with John Deere Management there must be one that uses a tractor.
ken
