Quirky and OCD tendencies..... Anyone else have them?

[Howling]

That would require tools from the 1st drawer....

No No...

Screwdrivers should flat blades with handles along front of drawer. Phillips handles along back of drawer. Arranged from large to small.

 

[goeduck]

No No...

Screwdrivers should flat blades with handles along front of drawer. Phillips handles along back of drawer. Arranged from large to small.

Sounds kinda screwy to me

 

[prichard]

Sounds kinda screwy to me

This whole thread is screwy. What's your point?

 

[Pixguy]

This whole thread is screwy. What's your point?

Hey.... I resemble that remark! :laughing:

 

[PILOON]

Screw U, LOL

 

[Ken]

It痴 not as bad as when the paint store guy doesn稚 put the hole on a 5 gallon pail in line with the handle.

4570 Do you pour from 5 gal bucket with the hole up or down. Down will suck in air and cause the paint splatter. up the paint will run out but across the top if not careful.
ken

 

[4570Man]

I pour the metal cans of paint thinner and quart oil bottles with the hole on the top side. I pour the 5 gallon cans hole down. I usually lay the bucket on it’s side with the paint tray under it and compress the bucket with my knee. I could see how pouring it spout up could work too though.

 

[Ken]

I pour the metal cans of paint thinner and quart oil bottles with the hole on the top side. I pour the 5 gallon cans hole down. I usually lay the bucket on it’s side with the paint tray under it and compress the bucket with my knee. I could see how pouring it spout up could work too though.

l learned this trying to pour Hydraulic fluid into the off set fill hole of John Deere tractor. pointing at the roll over bar bolting location under the cross bar holding the seat. Some where with John Deere Management there must be one that uses a tractor.
ken