Repaired 8N stalling when trying to open up the throttle (yes, me again)

   / Repaired 8N stalling when trying to open up the throttle (yes, me again)
  • Thread Starter
#31  
I ask because I tried it as full turns, as you describe, and it ran worse. I was thinking I was making too large of changes. I will try again tonight and will also spray some starting fluid where the carb meets the manifold to make sure the vacuum leak is gone.
 
   / Repaired 8N stalling when trying to open up the throttle (yes, me again) #32  
Also check intake manifold to head area for vacuum leaks
 
   / Repaired 8N stalling when trying to open up the throttle (yes, me again)
  • Thread Starter
#33  
OK, checked for vacuum leaks and there are none. I started fresh with the carb and with 5 turns for both the air and main needles it started to run OK. Not great at high RPM -- but OK. Once I got the throttle in a good spot I dusted off the snow and head off to plow the road. I never adjusted the throttle but she worked well and provided plenty of power to get the road clear.

Thanks for the help, guys. I will keep my eyes out for a new carb if she can make it through winter without another major breakdown.
 
   / Repaired 8N stalling when trying to open up the throttle (yes, me again) #34  
5 turns of the main? you have a fuel restriction.. or VERY dirty carb.. or no venturi.

5 turns of the air?

Are you seeing an issue here.

turns OUT on the main enrich the mix.

turns OUT on the idle LEAN the mix.

yer carb is fubar....
 
   / Repaired 8N stalling when trying to open up the throttle (yes, me again) #35  
"yer carb is fubar...." :laughing:
 
   / Repaired 8N stalling when trying to open up the throttle (yes, me again) #36  
he's leaning out one circuit and way over enriching the other. and needing that much adjustment means fuel system desperately needs help.
 
   / Repaired 8N stalling when trying to open up the throttle (yes, me again) #39  
   / Repaired 8N stalling when trying to open up the throttle (yes, me again) #40  
I remember when I had a similar issue with my 45 2n it was stalling and losing power loaded or unloaded it ended up being the cheap points I bought and the timing was off because the points were so poorly made.
 

Tractor & Equipment Auctions

Case-IH 180 Magnum (A57148)
Case-IH 180 Magnum...
Mini Jack Daniels Truck (A55853)
Mini Jack Daniels...
2013 PETERBILT 367 DAYCAB (A58214)
2013 PETERBILT 367...
INGERSOLL RAND  G25 GENERATOR (A58216)
INGERSOLL RAND...
2010 MAXEY WELDING 20 T/A GOOSENECK TRAILER (A55745)
2010 MAXEY WELDING...
2013 FORD F-350 FLATBED (A58214)
2013 FORD F-350...
 
Top