selector valve

[kennyd]

Here is what I figured out. I think it is the regen that is causing the problems. I think I am going to change things around so I use the raise and lower function to control the selector valve.
Bill

You got it! The regen should not be active for the whole travel of the joystick though...

 

[Hooked_on_HP]

I switch things arround this morning so I am using the raise and lower functions on the FEL valve and every thing is fine.
kennyd, is there any way to adjust the regen. The regen seems to function through the whole dump cycle whether I move the joystick a little or move it to full dump.
Bill

 

[kennyd]

I switch things arround this morning so I am using the raise and lower functions on the FEL valve and every thing is fine.
kennyd, is there any way to adjust the regen. The regen seems to function through the whole dump cycle whether I move the joystick a little or move it to full dump.
Bill

No adjustment...you must have a 3-position valve on your machine...read THIS post for more info.

 

[Hooked_on_HP]

Well I am still having problems with this valve. The garpple works perfect now. The problem I am having now is with the up and down with the loader.When I am below 1500 rpm's every thing is fine. When I raise the rpm's higher and raise the bucket it goes slower. It goes down fine. So I switched the lines going into the selector valve from the FEL valve and switched the lines going from the selector valve to the lift arms so I an useing the valve in the other direction. Now it goes up fine but come down slow.I am going to dissamble the valve tomorrow and see if I have some kind of blockage.
Bill

 

[EFLBIKER]

OK, i've ordered the valve, the DPDT switch, wired connectors. All this is going on a JD4310 W/ 3rd SCV.

Valve

DPDT Switch

Wired DT06-2S Connectors And Mounting Clips


Can someone look at my sketch and let me know if this is the way to wire it all up.

Thanks,

 

[6sunset6]

I do not understand your switch wiring. look at my attachment.
you need two double pole switches. Do nothing the priority port flows.
Pick sol 1 and 2 and port 2 flows. Pick sol 1 and 3 and port 3 flows.

 

[EFLBIKER]

the sketch says it can be wired up with one DPDT switch? can you make a sketch of it please.

 

[6sunset6]

You need two double pole switches. Unless you have a rocker center off, double pole one way and double pole the other way.
My sketch showa 2 separate switches. Thats how I did it. I just looked at the switch you picked. It is a rocker on off on DPDT.
It should work I think the center commons get tied to +12. Then the NO contact on each side of one pole get teid together and to sol 1. The other pole NO one contact to sol 2 and the other contact to sol 3. I think.

 

[EFLBIKER]

OK, I think I got it now. It should be like this?

 

[6sunset6]

yes HMM yes was to short to post had to add comment