T-posts in hard ground - a hack

   / T-posts in hard ground - a hack
  • Thread Starter
#12  
you didn't want to press them down with your bucket? also I have seen some people who bolt a spear on their bucket and they sink it in a foot or so then you put your post in the hole and press it some more with the bucket.
Very steep - no way to get a tractor near there - it was even hard to stand as I pounded.
 
   / T-posts in hard ground - a hack
  • Thread Starter
#13  
Adapt and overcome. You have a challenging task. No way I could manual drive 100 T posts in any amount of time considered efficient. :(
Yeah - very challenging - without the drill hack I would have not gotten this far - I think I have about 55-60 or so in already. The good news is that from now on the ground is a bit more level - not level - just not so steep. I will get back at it in a few days. I need to pick up some more posts. And they are costing about $1.50 more per post (6') than I recall.
 
   / T-posts in hard ground - a hack #15  
That's tough work. Way to go @beowulf!

All the best, Peter
 
   / T-posts in hard ground - a hack #18  
The one Agri-Supply sells is hundreds cheaper. I won't buy squat from Northern Tool, all their offerings are overpriced.
 
   / T-posts in hard ground - a hack #19  
Draagging that pounder weighing 30 pounds plus the Tposts, beowulf would be exhausted. Jon
A standard t-post driver weights about 20 pounds so 10 more pounds and you don't have to repeatedly pick up and drop it. I think its a clear winner other than cost.
 

Tractor & Equipment Auctions

John Deere 7230 131HP 4WD Agricultural Utility Tractor (A56857)
John Deere 7230...
BOSS 990 Fuel Trailer - 990 Gallon Farm Diesel Tank, Field Refueling Solution (A55315)
BOSS 990 Fuel...
Pallet of UV Solid Hardwood Flooring (A55758)
Pallet of UV Solid...
2020 MACK GRANITE (A58214)
2020 MACK GRANITE...
John Deere 1025R (A53317)
John Deere 1025R...
2011 Kenworth T7 Series (A55973)
2011 Kenworth T7...
 
Top