T-posts in hard ground - a hack

   / T-posts in hard ground - a hack
  • Thread Starter
#12  
you didn't want to press them down with your bucket? also I have seen some people who bolt a spear on their bucket and they sink it in a foot or so then you put your post in the hole and press it some more with the bucket.
Very steep - no way to get a tractor near there - it was even hard to stand as I pounded.
 
   / T-posts in hard ground - a hack
  • Thread Starter
#13  
Adapt and overcome. You have a challenging task. No way I could manual drive 100 T posts in any amount of time considered efficient. :(
Yeah - very challenging - without the drill hack I would have not gotten this far - I think I have about 55-60 or so in already. The good news is that from now on the ground is a bit more level - not level - just not so steep. I will get back at it in a few days. I need to pick up some more posts. And they are costing about $1.50 more per post (6') than I recall.
 
   / T-posts in hard ground - a hack #15  
That's tough work. Way to go @beowulf!

All the best, Peter
 
   / T-posts in hard ground - a hack #18  
The one Agri-Supply sells is hundreds cheaper. I won't buy squat from Northern Tool, all their offerings are overpriced.
 
   / T-posts in hard ground - a hack #19  
Draagging that pounder weighing 30 pounds plus the Tposts, beowulf would be exhausted. Jon
A standard t-post driver weights about 20 pounds so 10 more pounds and you don't have to repeatedly pick up and drop it. I think its a clear winner other than cost.
 

Tractor & Equipment Auctions

S/N: 5D121002416 (A55787)
S/N: 5D121002416...
UNUSED FUTURE 32" HYD TILTING BUCKET (A52706)
UNUSED FUTURE 32"...
2014 UTILITY VS2RA 53FT REEFER TRAILER (A57880)
2014 UTILITY VS2RA...
Mahindra 6065PST (A53317)
Mahindra 6065PST...
Neckover GL24-2-7K Gooseneck Trailer  24ft Deck, Dual 7K Axles, 14K GVWR (A56435)
Neckover GL24-2-7K...
Yamaha (A55758)
Yamaha (A55758)
 
Top