polaris
Member
Steve do you have a tooth bar for a john deere 73" HD bucket? Is it a direct bolt on fit? If so what is the price Thanks Polaris
Tooth Bar Pricing Guide
- Thread starter Anonymous Poster
- Start date
- Views: 2456
Steve_Carver
Approved Advertiser
sure.... approx. $310 + shipment cost.
just need the exact inside measurement ... side to side
100% satisfaction or send it back for refund
email toothbar@carverequipment.com
thanks
sc
just need the exact inside measurement ... side to side
100% satisfaction or send it back for refund
email toothbar@carverequipment.com
thanks
sc
OP
Anonymous Poster
Epic Contributor
- Joined
- Sep 27, 2005
- Messages
- 29,678
ForceTen
Bronze Member
Steve,
I need a toothbar for my NH 16LA HD bucket (72"). Are you familiar with this bucket, or do I need to send you the measurements? Also, are there any additional measurements that you need besides the inside width? And finally, I want to get two bolt on cutting edges for the sides of my bucket (to reinforce the bucket sides - they take a beating with the work I do). Would you be willing to take a shot at making those?
Steve
There are old pilots, and there are bold pilots, but there are very, very few old bold pilots. And they get scarcer every day.
I need a toothbar for my NH 16LA HD bucket (72"). Are you familiar with this bucket, or do I need to send you the measurements? Also, are there any additional measurements that you need besides the inside width? And finally, I want to get two bolt on cutting edges for the sides of my bucket (to reinforce the bucket sides - they take a beating with the work I do). Would you be willing to take a shot at making those?
Steve
There are old pilots, and there are bold pilots, but there are very, very few old bold pilots. And they get scarcer every day.
