dodge man
Super Star Member
On my JD the top link has little levers sticking out to turn it. I often get the jamb nut where I want it and then use the levers on the top link to tighten it up to the jamb nut. It seems to hold.
Top Link Jam Nut
- Thread starter N750A
- Start date
- Views: 8910
Gordon Gould
Super Member
- Joined
- Apr 1, 2007
- Messages
- 6,703
- Location
- NorthEastern, VT
- Tractor
- Kubota L3010DT, Kubota M5640SUD, Dresser TD7G Dozer
I give a small tug with a wrench on the jam nut. My problem is when removing the implement I sometimes forget to loosen the jam nut BEFORE I pull the pin at the implement connection. If I do that I have problem loosening the jam nut when I mount the next implement. Just a maddening pain.
gg
gg
gstrom99
Elite Member
- Joined
- Nov 4, 2015
- Messages
- 2,547
- Location
- Greene, Iowa
- Tractor
- Deere 855, Deere 530R zero turn, Allis Chalmers D17 III, Polaris Ranger, Deere 3032E (SIL's), Yamaha Timberwolf 250, Husky saws, H & H 10k and Carry-On trailers
My Deere 855 came with 3" studs welded to each side of the nut. No tools needed.
Little Red Tractor
Platinum Member
I always snug it up with a wrench...it's a pain in the neck; but it stays where I put it.
RalphVa
Super Member
- Joined
- Dec 19, 2003
- Messages
- 7,902
- Location
- Charlottesville, VA, USA
- Tractor
- JD 2025R, previously Gravely 5650 & JD 4010 & JD 1025R
My experience is it needs to be wrench tightened.
I have a Kubota M7060. I tighten it with a wrench and it will still loosen after several hours with the 10 foot flail. Drives me crazy.
I wonder if two nuts would be a cheap better system. Like the way two nuts on a steel fishing rod reel seat rarely loosen. Only one nut on a steel reel seat is useless.
I wonder if two nuts would be a cheap better system. Like the way two nuts on a steel fishing rod reel seat rarely loosen. Only one nut on a steel reel seat is useless.
