Looking for an application if there is one that uses a rear wheel weight that is held on by 6 bolts to fit to a Yanmar tractor with 11.2 x 24" wheels.
The bolt hole centers are 11 3/8" that the weights would be held on by and the holes are 11/16 (17mm), and the center hole inside dia would have to be 8 3/8" to clear the lug bolts, the outside dia could be as much as 18" depending on the design.
JD 110# weights are held on by 4 bolts or at least the ones I have found do, I really would like a direct fit. I would also like weights in the 100-150# range each if possible.
I am not interested in liquid ballast or building a weight out of iron/concrete etc unless its absolutely the only way. I plan on taking them on and off seasonaly and want a nice looking addition for my tractor like factory parts.
thanks for any help.
The bolt hole centers are 11 3/8" that the weights would be held on by and the holes are 11/16 (17mm), and the center hole inside dia would have to be 8 3/8" to clear the lug bolts, the outside dia could be as much as 18" depending on the design.
JD 110# weights are held on by 4 bolts or at least the ones I have found do, I really would like a direct fit. I would also like weights in the 100-150# range each if possible.
I am not interested in liquid ballast or building a weight out of iron/concrete etc unless its absolutely the only way. I plan on taking them on and off seasonaly and want a nice looking addition for my tractor like factory parts.
thanks for any help.