Which PowerService

   / Which PowerService #31  
Is that right?! If you gell up; PowerService 911 Diesel can right the wrongs of those nasty paraffins? I'm assuming that you would still have to drop the filter and replace with a new one, yes? I've had diesels a few years now and (knock on forehead..) never had a problem until this year when my 970 quit me one morning at -2 degrees. I'd already used the tractor this winter during a couple of early cold snaps that got down to -12F and no problemo. So, it was a surprise that my Rotella fuel treatment didn't move those waxy globs down the pipe for me this past week. /forums/images/graemlins/mad.gif Good tip for furture reference, thanks. AKfish
 
   / Which PowerService #32  
No filter change....just dump a bottle in the tank (read the directions for smaller capacities), go inside and have a hot toddy and then when you are warm and toasty, go fire it up.

I have 100 gallons on each side and a bottle on each side does the trick.
 
   / Which PowerService #33  
</font><font color="blue" class="small">( soundguy, why don't you just use the silver bottle. same stuff without the anti gel.
)</font>

Locally, most places just carry the white bottle.. I occasionaly see the silver bottle at TSC.. but it is the same price..

Soundguy
 
   / Which PowerService #34  
I've got a 275 gallon tank for a fuel station. I used the gray stuff in it back in September. It's been down to 20 below here and I haven't have a problem yet. Is there a way to test how much protection I have? Maybe I should get some of the white bottle and add to be on the safe side. Or add some kerosene.
 
   / Which PowerService #35  
</font><font color="blue" class="small">( Is there a way to test how much protection I have? )</font>

Set a little jar of treated fuel outdoors where it will get colder than the tractor. Watch the jar.
 
   / Which PowerService
  • Thread Starter
#36  
</font><font color="blue" class="small">( My white bottle Powerservice has a foil anti-tamper seal over the opening. I simply poked a screwdriver-sized hole in the foil near one side and a smaller hole in the foil on the other side. Now I can pour it at a 90 degree angle and a little stream just shoots out. No dribbles or anything.)</font>

This is probably the best piece of advice I've heard yet. I did it last time around, and it poured perfectly w/o any mess. As they say in the Guiness commercials, "Brilliant!!"

Jay
 
   / Which PowerService #37  
Geesh, now that wasn't too hard to figure out was it. Now I feeel stupid.
 

Tractor & Equipment Auctions

2024 CATERPILLAR 255 SKID STEER (A51246)
2024 CATERPILLAR...
1992 Peterbilt 377 Sleeper Cab (A52748)
1992 Peterbilt 377...
2018 WACKER NEUSON CORPORATION DBA WACKER NEUSON LTV6 LIGHT TOWER (A52472)
2018 WACKER NEUSON...
2018 XCMG XE210CU CRAWLER EXCAVATOR (A52576)
2018 XCMG XE210CU...
2024 BCL Fabrication Landscape Dump Trailer - Heavy-Duty Utility Trailer for Mulch Debris Hauling (A52748)
2024 BCL...
CLARK GCS20MB 4K CUSHION TIRE LPG FORKLIFT (A52472)
CLARK GCS20MB 4K...
 
Top