Work Light Out

bcp301 · Apr 22, 2014

Hi All
Can anyone tell me how to change out one of my work lights mounted on roll bar? Pics included. I believe it's a one piece cover and bulb but am curious how/where to get a replacement? From Kubota dealer perhaps? If it's not a one piece unit how to rewire bulb? How to remove from casing?

Thank you!

Brian P

RG1 · Apr 22, 2014

deete please. duplicate post for some reason.

RG1 · Apr 22, 2014

A couple pics of the back and undersides side would be a big help.

George2615 · Apr 22, 2014

I don't have a Kubota but have seen similar lights. Look around the outer circle of the bulb itself. The ones I've seen have a wire snap ring that holds the bulb in. If yours has this ring you'll need a small screwdriver or needle nose pliers to get it out. Once the ring is removed the bulb will fall out.

countrybumpkin · Apr 22, 2014

The bulb just prys out of the rubber housing with the help of a small flat tip screw driver.

oosik · Apr 23, 2014

Looks a lot like my backup light. Mine disassembles just like George2615 (post #4) says. The bulb is a one piece unit and plugs into a plastic fixture on the end of three wires. Replacement bulbs available at NAPA.

farmeratheart · Apr 23, 2014

I had sealed beams that looked a lot like that on my previous tractor. Available from Tractor Supply for about 10 or 12 dollars. Another route to go if you can't seem to extract a bulb from the current set-up.

Frank