YM2000 Alternator testing

   / YM2000 Alternator testing #1  

Mslater

New member
Joined
Nov 19, 2004
Messages
12
Location
Baton Rouge LA
Tractor
YM2000
Ok, I set my meter on ac and test which outputs? Thanks!
 
   / YM2000 Alternator testing #2  
You want DC, put leads across your battery terminals, looking for +14vdc+- at high idle.
 
   / YM2000 Alternator testing
  • Thread Starter
#3  
Thanks I'll check it out again!
 
   / YM2000 Alternator testing
  • Thread Starter
#4  
I checked at the batt running at about 1500 rpm and get 12.3 volts. Now that I know its not charging how to I narrow it down? Whats the procedure to test the alternator seperately? Thanks alot for your help!
 
   / YM2000 Alternator testing #5  
I'm not sure if your bridge rectifier is in the alternator or the regulator; however, you can unplug the regulator from the alternator and meter across the alternator post and look for +20+- volts on AC or DC scale. No voltage says bad alternator, +20+- says bad regulator, AC or DC reading gives the location of the rectifier, which changes voltage from AC to DC. It's usually a bad regulator.
 
   / YM2000 Alternator testing
  • Thread Starter
#6  
Gotcha, I'll give it a shot tomorrow. Thanks again!
 

Tractor & Equipment Auctions

2022 Polaris Ranger 4x4 Utility Cart (A51691)
2022 Polaris...
CFG Industrial Q.A Hydraulic Breaker (A50121)
CFG Industrial Q.A...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
STORAGE FEES (A52576)
STORAGE FEES (A52576)
2005 Ford F-150 XLT (A50120)
2005 Ford F-150...
2020 KUBOTA RTV X1100C UTV (A51406)
2020 KUBOTA RTV...
 
Top