clemsonfor
Super Member
Yep Carey is correct
ZEN-NOH YM1500
- Thread starter cassml1
- Start date
- Views: 18795
EddieH
New member
Hello everybody I'm new to the fourm and I'm in need of some help. I have a YM1500 and I'm having issues with the 3 point arms not raising after I done a filter and fluid change. I was reading on here and did notice another member that had the same problem and I tried contacting him to see if he could tell me how he fixed his but I haven't got a reply yet. but if anybody has any ideas of what it might be I would greatly appreciate it.
If you are confident you have your suction pipe back on without leaks (hose connections, joint bolt gaskets) I would then loosen off just a tad the joint bolt where the high pressure line goes into the 3 point control. Put a rag over it and only set the tractor at idle. If you get nothing I would then remove the suction line from the top of the pump and fill the pump with fluid and try again.
clemsonfor
Super Member
Winston ideas are as good as any. These things self prime. Apparently this has happened before but this is the first I recall
