schmism;1534856 Sounds like a good alternative. Let us know how it does on fuel use.[/quote said:With the brush cutter I burn about .75-1.0 gph the last time I really paid attention. I have the 17 HP engine. I assume the genset would burn the same gph. The engine runs at the same RPM with the brush cutter or genset attached.
Later,
Dan
I have a Generac 6500 watt (8500 peak demand) construction generator that I used at our last place more than a few times. I think the longest was three days.
Noisy and a gas pig but it got the job done."
I think I have the same unit about 4 years old with a Briggs Engine and have to agree about the noise and fuel consumption. I do like the removable fuel tank and the large diameter wheels for dragging it outside of the garage. If I leave the fuel supply turned to the on position it will typically start on the first pull. I believe the newer ones have a Generac Engine vs. the Briggs.
Good point on depth of well taking more power to get all that water moving. My well is in the 175-200ft deep range and it only has a 1/3 hp motor on it. I have been looking at a 6500 watt generator.. so I should be all set. I tried to go with a smaller 3000 watt inverter type... but if the refrigerator/ well pump and a few lights are on at the same time... then that is over the limit, especially for startup.Jim, a couple of thoughts that I have not seen here. How deep is your well? I have a 330 foot well and the 4 KW generator would not start it. I ended up with an 8 KW and it does OK. My 5 KW is marginal on starting the well.
Mine is new and I have been monitoring it, runs about 30% of the time.. which helps. It is the startup current in the fridge that is killer, running current is not too bad.Your refrigerator will need to run more than a few hours a day. Mine typically run 50% of the time during normal usage.
I was looking at the Honda Inverter model, it is enclosed and has very low dB (59) rating, clean power, fuel efficient and is very tempting... just not the $3800 price tag.I can hear in the bedroom, but I don't run it after bedtime, so no problem. The Honda's are much quieter, so they would be a good choice. Good luck.
I bought this one back in 1998. It has the Generac engine on it and though it is a hard pull, it usually starts on the first pull if not the second.I have a Generac 6500 watt (8500 peak demand) construction generator that I used at our last place more than a few times. I think the longest was three days.
Noisy and a gas pig but it got the job done."
I think I have the same unit about 4 years old with a Briggs Engine and have to agree about the noise and fuel consumption. I do like the removable fuel tank and the large diameter wheels for dragging it outside of the garage. If I leave the fuel supply turned to the on position it will typically start on the first pull. I believe the newer ones have a Generac Engine vs. the Briggs.
Re: the well depth.
The deep well at my last place was about 275 feet with a half horse pump. Surviving a couple of lightning hits, the pump quit about a year ago at age 20. It was on a sunday morning and I was due to work so I called a friend who is in the business and we could not pull it so we called another who brought his pump puller. I never did measure it but anyway, we went to a 3/4hp pump.
With both the 1/2hp and the 3/4hp, you could hear the generator rev up a bit with a momentary dimming of the lights but it did not overload.
At that particular location, we would observe some dimming with the fridge or the pump coming on. It did not bother me enough to persue why. The generator dimming was about the same.