BackRoad
Platinum Member
I used my heat gun to customize the bend in a piece of 1inch plastic electrical conduit to attach to my subsoiler for burying a cable.
Worked well, but there was a point where it was firm...then in seconds it got very soft and almost too bendable...
You did well to get an entire length of PVC to a workable temperature!
Guessing the area around the holes for the U bolts may be the weakest point, with some of the most stress?
Do you think it might be worth adding some metal straps for reinforcement?
Worked well, but there was a point where it was firm...then in seconds it got very soft and almost too bendable...
You did well to get an entire length of PVC to a workable temperature!
Guessing the area around the holes for the U bolts may be the weakest point, with some of the most stress?
Do you think it might be worth adding some metal straps for reinforcement?