mahindra

Finally finished, barely fit even with their smallest option the Single BOGL, will test it in a bit Used a diverter kit from Artilian.

Hello, just joined. I recently traded my 1982 Kubota M4050 for the 2002 Mahindra 5005 with a ML214 Loader (plus a few $). Had the Kubota for a few years and did a good bit of work to get it right, but it was long in the tooth (3,500+ hrs) and did not have a loader. The 5005 popped up from a...

I've searched a lot, can't find if Mitsubishi S3L2-Turbo has iron or alum head.

I was moving some logs with the grapple and i went to raise the FEL and nothing. All other functions work as normal but when i pull the control back to raise it doesn't raise and feel very limp. I took the cover off of the controls and it looks like 2 cables going down under the tractor to...

Hello tractor peeps, I have recently purchased a non-US sold Mitsubishi MT25C and was on the hunt for some manuals to be able to figure things out and get some stuff hopefully fixed. I decided to scrub the interwebs and figured "Well, it's a Japanese tractor and it wasn't sold in the US so I...

Have a 3016hst using it the other day getting garden ready was running fine went and put fuel in it and shut off, once done fueling went to start and acted like battery was dead, tested battery and it was on the weaker side so replaced with new, still the same thing maybe crank one or 2...

Howdy I have a 3550 and the throttle slowly lets off while driving so have to continuously give more throttle then lets off slowly or have to hold the lever to correct speed. Any idea where to start to correct this thanks

Is there a lever for the locker i keep hitting or is it mechanical and locks when it feels spinning?

I have been working on and off on my Mahindra 2555 for months now. I had a bad knock and a lot of white smoke. Could not determine the problem. Finally, this week I removed the engine and found that cylinder 2 and 3 the connecting rod bearings were totally gone. Cylinder 1 was fine. To my...

Good afternoon everyone, I recently purchased a Mahindra 5500, the tractor will only start and run by bleeding the 4 injectors. Once you crack the lines and bleed the air it starts and runs like a dream, I haven't hooked anything to it to do work with, but it seems to run fine with no lack of...

New member here. I’m trying to diagnose a glow plug circuit issue. My glow plug light only comes on for 1 second before it goes out regardless of what the coolant temperature is. I have the service manual for the tractor but it’s not very helpful. It says it should have a go relay, gp timer and...

I have a 05 Mahindra 3505. Looking into the wiring friar it shows black, red, and blue wire going into a “e.t.g.” Can someone explain what a etg is? I searched all over the manual and it does not explain

I was using the loader to move gravel the other day and the tractor stalled out. I tried restarting it, but it would not turn over. The starter was turning, but it would not catch. Since it was close to dark, I left it where it was in the yard. I went out this morning to try to get it to...

I am a dealer in the Northeast. Currently I am a Yanmar dealer (great machines, but not great dealer surport from Yanmar). I also have my Bad Boy mower dealer pestering to bring on their tractors. I am opening a new store around 30 miles away in which I would have access to bring in a new...

I have read a lot about greasing the bucket on my tractor… I have been told you can’t grease it too much when using the bucket pretty much exclusively with my current project - what are others thoughts?

Hi all: I have a 2615HST that is as dead as can be. It's likely a wiring issue, but I don't have a manual or a wiring diagram. The issue is that even with a freshly charged battery, nothing happens when I turn the key. No dashboard lights, no solenoid clicking. Nothing. I've looked for...

Mahindra Max-24 This seems a silly question, but I am missing 2 bolts that hold down what appears to be a spring-tensioned-band, located underneath the seat pan cover plate, and behind and above the rear PTO assembly. The band when unbolted sits at a 45-degree angle and requires a bit of...

2021 Mihandra EMAX 20S with only 87 hours - the Joystick lever is already stripped and came out into my hand!!!! Has anyone else has this issue?

I have Mahindra 475 DI and when driving below 900 rpm it starts to have problems, the rpm is unstable and the tractor have uneven power, the tractor shakes forward-backwards forward-backwards, but the engine works fine when tractor is not moving( it sounds like problem with delivering fuel when...

I wanted to do a write up of my experience with my 2021 Mahindra 4540 here on the forums to hopefully give other owners who may be Googling the same issues with their tractor. The General Situation: If you haven't seen my other posts, I purchased my 4540 4wd FEL in October of 2021 brand new. I...

Buy an Ultimate Rack Combo and Save $300! Our best selling Ultimate Rack Combos just got better! Order a combo and enter code: QH2023 at checkout to save $300 off your order, we'll even throw in a free 5n1 Tool Holder! That's over $500 in savings when you include free shipping ORDER HERE .

Hey folks, pulling the trigger on my tractor in March. That's when I'm actually moving onto my land. I've narrowed it down to the Mahindra 5145 Pros: -Heavy heavy tank -400 pounds stronger loader -Test drove and really like it -4 dealers within two hours Cons: -Shuttle only -MCRD -ECU ran...

Next summer we are planning on moving from south Georgia to Maine.. yes, Maine.. yes, we know, it's cold there.. lol... We bought 26 acres off-grid and I will need to do a lot of clearing.. making roads.. a lot of digging.. fel work.. grapple (trees, limbs, rocks) and snow plowing as the...

Hello, I am new to tractors and have just purchased a used Mahindra 5500 with a bit less than 500 hours on it. I'm trying to figure out what all the gears and knobs and pedals do and it would be very helpful if someone had a manual for this series. I can figure out how to go backwards and...

I purchased a Max 26 without the belly mower. I will get a 3pt finish mower for it. The dealer said the recommended implement size is 48" for basically everything except a rake. I find it hard to believe this 26hp machine can't handle at least a 60" 3pt finish mower. Does anyone have real world...

We almost never have any discounts/coupons/sales, but heeeere we go! www.EverythingAttachments.com Travis

Hi. Just recently bought a new 2022 Mahindra 5155 4x4. I’ve put 12 hours on it so far. About 1 out of every 4 reverse shifts on the synchro lever it kicks out of gear and horrible grinding sound. Hasn’t done it in forward at all only reverse. I messaged the dealer I bought it from and he says “I...

I have a 2005 TYM HST330 which has mostly served me well. Made by TYM, it was also sold as the Mahindra 3510 (so you Mahindra owners might have a suggestion here). I bought it used in 2010 with 191 hours on it and recently passed 700. It has an SCV (secondary control valve) and its control...

All-- I have a Mahindra 5545, 4wd. Today, it ran very well earlier, but when I started it to do a little backhoe work it began smoking from the exhaust and running very rough and would not produce any power. This happened a couple of years ago, as well. Back then, I had made up my mind to haul...

Ok I wanted to write this up partially to inform others as well as to vent a bit with this experience. First as a Disclaimer, I have had no problems out of my Mahindra for the 50hr I have owned it. I have been used to running various JD compacts and the main thing I realized about this tractor...

I just bought a Mahindra 4540 a couple weeks ago. We have about 17hrs on it. It blew a 40a fuse after about 15hrs. Blew it again a day or two later. Now at it’s blowing just about every time we turn it off. The dealer we bought it from said to just swap the 40a for a 60a. We didn’t feel...

I recently got a pretty good deal on a Mahindra 3525. I want to add a backhoe but can not find what backhoe to look for or if it is even possible

I have a 2017 Mahindra E25. My water pump has been leaking for a bit now and I have one on order. So up till now I have just been filling the tank with water before I use it and it would get me a few hours of use before getting too hot. I was using it the ither night and it got hot on me and...

Probably a dumb question, but where is the main engine oil dipstick located on an older model Mahindra 4500 2-wheel drive tractor? I've looked everywhere for that sucker. thanks in advance.

Hello, Mahindra 1533 HST won't start, sounds like it isn't getting fuel. Turns over strong. Please see video linked below. I'm trying to highlight that when the key is in the on position, the relay shown makes a buzzing sound but I'm not positive if it is abnormal. Also, the temperature gauge...

Is there a trenching bucket compatible with the 60B backhoe on my 2638 HST? thanks Keith

Mahendra 4035 shuttle won't shift out of neutral unless transmission is in neutral. And, transmission won't shift out of neutral if shuttle is in forward or reverse. Any help would be appreciated. Thanks, Jeff