1026r curl function backflow

   / 1026r curl function backflow #1  

swick1

Platinum Member
Joined
Jul 11, 2007
Messages
860
Location
WV
Tractor
John Deere 1026R
When I have to curl with my pallet forks on unless I move the valve all the way open very fast I get backflow through the circuit and the forks drop a couple of inches before curling back properly. Is there an easy fix to this problem? It makes bulky items scary to lift.
 
   / 1026r curl function backflow
  • Thread Starter
#3  
Where would this valve be located? Before the valve block?
 
   / 1026r curl function backflow #4  
I think this is a known issue with the 1-series -- talk to your dealer about it. There is a fix they can apply.
 
   / 1026r curl function backflow #5  
I had the same problem. The dealer replaced the SCV and everything worked properly after that.
 
   / 1026r curl function backflow
  • Thread Starter
#6  
Thanks. I'll visit them tomorrow and let you know what they say!
 
   / 1026r curl function backflow #7  
The load check valve is usually in between the work ports.

Remove and inspect, clean, or replace.
 
   / 1026r curl function backflow
  • Thread Starter
#8  
They say the dropping is normal and all the 2000psi tractors do it
 
   / 1026r curl function backflow #9  
Don't buy that -- they are selling you a line of BS. It should not do that.
 

Tractor & Equipment Auctions

2015 Kioti RX6620 Tractor with Loader (A50490)
2015 Kioti RX6620...
Toro Sand Pro 5040 Bunker Rake (A49346)
Toro Sand Pro 5040...
2015 FREIGHTLINER CA125SLP SLEEPER (A51219)
2015 FREIGHTLINER...
2012 Chevrolet Silverado 1500 LTZ Crew Cab Pickup Truck (A48081)
2012 Chevrolet...
UNUSED Grey Corrugated Polycarbonate Roof Panels (A50860)
UNUSED Grey...
2015 Ford Transit 250 Cargo Van (A48081)
2015 Ford Transit...
 
Top