Steve_Miller
Veteran Member
Finally getting around to post some pictures of my diverter I installed on my CK20.
1st pic. Diverter and relay are mounted under left side floor board between FEL valve and rear fender.
2nd pic. Side view of tractor, tried to keep things as hidden as possible.
3rd pic. This is the opposite side where the line tee's to the front/side and the back outlets located just behind the tool box.
4th pic. This is my joystick switch. I used a relay as this is a very light duty switch because of it's size and probably wouldn't handle the continuous on/off cycles of the solenoid.
5th & 6th pics. These are two different angles of the back remotes.
7th pic. Side remotes for controlling my 4' snow wing I built a few years back.
8th pic. Front remotes for my grapple I built this past winter.
Any questions, i'm more than willing to try and answer.
Steve
1st pic. Diverter and relay are mounted under left side floor board between FEL valve and rear fender.
2nd pic. Side view of tractor, tried to keep things as hidden as possible.
3rd pic. This is the opposite side where the line tee's to the front/side and the back outlets located just behind the tool box.
4th pic. This is my joystick switch. I used a relay as this is a very light duty switch because of it's size and probably wouldn't handle the continuous on/off cycles of the solenoid.
5th & 6th pics. These are two different angles of the back remotes.
7th pic. Side remotes for controlling my 4' snow wing I built a few years back.
8th pic. Front remotes for my grapple I built this past winter.
Any questions, i'm more than willing to try and answer.
Steve