Anyone drilled a hole in the end of a pallet fork

   / Anyone drilled a hole in the end of a pallet fork #41  
You're daft. no one would do that......

IMG_0555.jpg

For the record, this was not my idea.
 
   / Anyone drilled a hole in the end of a pallet fork #42  
To accept a trailer ball for moving trailers around? Sounds like a reasonable idea unless I'm missing something.

Drill the hole and then weld a stiffener onto the bottom side of the fork.

Good luck and be careful out there.
 
   / Anyone drilled a hole in the end of a pallet fork #45  
I highly recommend against it. I did this on my old forks and the one with the hole and trailer ball over time got bent down. Not a lot but enough to make picking up pallets difficult. I never could get it straightened so I eventually got new forks and welded up a trailer mover that slips over both forks.

Exact same thing happened to me....
 
   / Anyone drilled a hole in the end of a pallet fork #46  
Cutting branches directly overhead while standing on a raised FEL bucket..... get hit by the branch first and get knocked off the FEL second. I hope someone had a phone to call 911.
 
   / Anyone drilled a hole in the end of a pallet fork #47  
Cutting branches directly overhead while standing on a raised FEL bucket..... get hit by the branch first and get knocked off the FEL second. I hope someone had a phone to call 911.

Like I said, wasn't my idea. However, the 2 branches being cut were long but skinny (see pic) and were hanging straight down by just a thread of bark--they got torn by a storm--and the tips were almost touching the ground. So not quite as dangerous perhaps as it appears at first glance. I could pick them up with one hand, so prolly not enough heft to seriously hurt anyone. In any case, I hired pros to do it, this was their best idea, and it was done without mishap. (This same crew also took down a dangerous, big heavy branch that had fallen on my house in the same storm, and they took all precautions, used ropes, sawed each branch into a zillion pieces starting at the ends, etc., and took hours to do it.)
 
 

Tractor & Equipment Auctions

2007 DRAGON 150 BBL ALUMINUM VACUUM TRAILER (A55745)
2007 DRAGON 150...
183 (A52705)
183 (A52705)
1965 Rodgers T/A Equipment Trailer (A53117)
1965 Rodgers T/A...
2019 Fecon BH74SS Hydraulic Mulcher High Flow Skid Steer Attachment (A51691)
2019 Fecon BH74SS...
2016 FORD F250 XL SUPER DUTY EXTENDED CAB TRUCK (A51247)
2016 FORD F250 XL...
Case 1816B Skidloader (RUNS) (A50775)
Case 1816B...
 
Top