Backhoe tooth broke

[Pixguy]

My GC 2410 has done jobs that push its limits before and breaking granite from this wall was just another challenge. I did succeed in pulling 4 attached pieces from the wall but this last one took a tooth out.

It looks like the tooth is welded. Does anyone have a source where I can order another tooth? btw, this little guy is amazing.

 

[Fawken]

If it were mine, I'd just weld a piece of sharpened 1/4" plate on where it broke off. I would use the 6013 tempering rods they sell at TSC.

 

[mguitas]

Ya the new ones can be replaced now.

 

[whis]

those look like they are replaceable, shank is welded on tooth slips over. tractor supply may have them.

 

[Leejohn]

Here you gooooo. Bucket Teeth For Excavator, Backhoe, Bulldozer, Skid Steer

 

[redman135]

When you get a replacement tooth make sure you get the lock pin as well. Most likely the lock pin worked itself out and you haven't actually broken anything.

 

[AxleHub]

Here you gooooo. Bucket Teeth For Excavator, Backhoe, Bulldozer, Skid Steer

Its unbelievable at the level of specialization . . . an entire business just about replacement teeth for buckets

 

[Rustyiron]

Pix, check with your dealer or a Bobcat dealer. I know them as a "fabricated" tooth. The little (Woods) backhoe I had had them and the tooth covers you are looking for are not pinned on. They were held on by hammering the side of the cover into a small detent on the shank. Not that great of a set up, I tack welded mine on & would still loose them. What ever you find, the fit to the shank on the bucket is the most important.

 

[Pixguy]

Thanks for all your responses guys. It does now seem like the tooth slides on without a pin and I will replace it and look at a way to tack or pin it.

 

[ksejeeper]

They might be the same on my MF backhoe. H&L 00 Weld on / crimp on. I replaced 4 on my Backhoe, I ordered and got them in 2 days.

HERE

 

[Pixguy]

They might be the same on my MF backhoe. H&L 00 Weld on / crimp on. I replaced 4 on my Backhoe, I ordered and got them in 2 days. HERE

Just ordered two of them. I hope they fit my 1" "post".

Thanks all

 

[Leejohn]

Maybe you guys would like to look at this.

http://www.hensleyind.com/parts_book/proprietary_products/pdf/Parabolics/156_160_220_Series.pdf

 

[jc21]

The current CB 65 backhoe uses bolt on teeth iirc ... could they be adapted to your bucket?