sokoservices
New member
Anyone have plans for a bucket hitch? Anyone used one before? Was wondering if they actually work and dont simply pull off of the bucket.
Bucket Hitch
- Thread starter sokoservices
- Start date
- Views: 3481
OP
sokoservices
New member
See the attachement.
Dr Dave
Platinum Member
I have one, with 2 clamp bolts, it wont stay put, slides side to side and works loose. I purchased a receiver housing from Northern Tool to weld on the top edge of my bucket. Its on my bucket list:laughing:
Dave
Dave
Blk88GT
Silver Member
I too have welded a receiver to the top of the bucket. It works great, although the bucket flexes a little when moving my larger trailers.
PapaPerk
Veteran Member
- Joined
- Jun 12, 2004
- Messages
- 2,293
- Location
- USA
- Tractor
- Kubota L3830, Ford Golden Jubilee, 1939 Sears Economy, Polaris Ranger 400, Honda Foreman 450 ES, 2004 Dodge Diesel 3500
Ahhh there it is.. was looking at your post with my iphone and didn't see it.
Yeah looks like it would pull off... unless you drilled a hole in the bucket for a pin.
gwdixon
Elite Member
It appears that there would be an issue with seeing the ball to easily hook up to the trailer. Maybe standing up would give a better sight line. I don't have that kind of set-up so don't know for sure.
Having a ball on the 3PH is very visible and no problem to get it lined up. The maneuverability is a bit less than with the ball on the front, of course.
Having a ball on the 3PH is very visible and no problem to get it lined up. The maneuverability is a bit less than with the ball on the front, of course.
buck12
Veteran Member
Katahdin
Platinum Member
Has anyone simply drilled a hole in the center edge of the bucket for a ball? Different shank sizes are available, could go with as small a hole as 5/8" for a 2000lb trailer.