Building a 3 point hitch for YM-146 GT-14 need some measurements

[gt14]

I am going to build a 3 point hitch for my YM-146 aka GT-14.

I am wondering if someone can help me with some measurements.

The schematic shows the components I am looking for the length of part 5 and its diameter.
I would also like to know how far part number 2 is from the part number 9.
What is the length of part number 9 center to center of outside holes.
What is the length of both arms of part number 2.


My idea is to use tapped pillow blocks and slide a shaft with a splined end into the pillow blocks. I will build two of part 9 one I will weld to the shaft the other I will weld in a splined coupler so I can slide it onto the shaft. I already have all other parts from my first attempt at this project 5 years ago.

 

[M E Race]

You might try giveing Hoye tractor a buzz. Chances are he might have the whole setup . Their # is 1-940-592-0181.
You also might try Jamieson tractor, they stock a lot of parts for the GT-14. Their # is1-570-253-4810. If nothing else they can help with measurments.
With the stock hydralics on the GT-14 they have a very limited lift capacity, but still perform well with cat O tool.