Grading BX front blade question

[LBrown59]

I'm in the process of setting up a BX1500 like this except it will have a rear tiller on the back instead of the back blade.

UP DATE
It's on the truck headed this way for delivery tomorrow.

 

[LBrown59]

Just for reference I paid $1900 plus tax for the control valve with stand, and hyd lines, the front mount and the 60" power angle blade. The skid shoes were $100 more, If I need them, I think I will make a set.
HarleyScooter

I just got the same blade .
Should be here tomorroww.
Paid $1500 installed, but I got lucky .

 

[LBrown59]

Tomorrow is *D Day for my BX1500 with The Hyd lift and angle front blade.
* Delivery.

 

[lamanated]

few yrs afterwards reading this post, I;m starting the mod, I;m not mounting the ram with the pin downward, rather I'm going 90 degrees so when the blade pivot point gets sloppy(which it will) the ram can pivot whereas if vertical, it cant pivot and will load up and wear.

 

[Rustyferrious]

few yrs afterwards reading this post, I;m starting the mod, I;m not mounting the ram with the pin downward, rather I'm going 90 degrees so when the blade pivot point gets sloppy(which it will) the ram can pivot whereas if vertical, it cant pivot and will load up and wear.

Lam, I'm not following. Do you have a photo of the set up? I got a BX2763A blade with my tractor and will be hooking it up for the first time shortly. Thanks,

 

[lamanated]

Correcting my last post, had a look at my my idea and it didnt work as planned,, back to both installed vertically...

 

[JackNBox]

I know this is an old thread but it is just the issue I am dealing with. I have a 2005 BX1500 and would like to put a quick hitch (BX2711) and front blade (TG2754) on it. It has never had a front loader and I have no Joystick or hydraulics for this so not sure where I can get what I need. Also not sure exactly what I need or if there is any manuals on how to install. The Kubota dealer was less that helpful saying that parts were no longer available.