escavader
Veteran Member
I had already purchased last night
Chainsaw Sharpening question
- Thread starter woodlandfarms
- Start date
- Views: 21644
SpringHollow
Elite Member
Call Amazon support - they can redirect the package back to themselves and then you can order the correct one. Or worse case, refuse delivery. But I will say Amazon is very good at these things. Not sure if you bought it directly from Amazon or not.
They say on their web site to only use diamond on carbide and to only use the CBN on steel.
Ken
They say on their web site to only use diamond on carbide and to only use the CBN on steel.
Ken
OP
woodlandfarms
Super Member
- Joined
- Jul 31, 2006
- Messages
- 6,148
- Location
- Los Angeles / SW Washington
- Tractor
- PowerTrac 1850, Kubota RTV x900
So in keeping with the dremel and this new material Ken is suggesting, I wonder if this would work
Buy 7123 Dremel Mounted Points from UseEnco
Buy 7123 Dremel Mounted Points from UseEnco
SpringHollow
Elite Member
None of those are CBN
Ken
Ken
escavader
Veteran Member
I checked a did get the cbn one .im counting on you to be correct on this ha ha ha no pressure
Sent from my iPhone using TractorByNet
Sent from my iPhone using TractorByNet
escavader
Veteran Member
So i got my wheel why the dressing stick shipped with it for cleaning ?
Sent from my iPhone using TractorByNet
Sent from my iPhone using TractorByNet
s219
Super Member
- Joined
- Dec 7, 2011
- Messages
- 8,607
- Location
- Virginia USA
- Tractor
- Kubota L3200, Deere X380, Kubota RTV-X
Not sure I speak your language, but dressing sticks are normally used to shape the wheel edge.
escavader
Veteran Member
We call them dressing stick or jointing stone in the lumber planing business
I found a paper they buried in the box its for cleaning and exposing new grit
Sent from my iPhone using TractorByNet
escavader
Veteran Member
Sent from my iPhone using TractorByNet
s219
Super Member
- Joined
- Dec 7, 2011
- Messages
- 8,607
- Location
- Virginia USA
- Tractor
- Kubota L3200, Deere X380, Kubota RTV-X
You won't need to clean or expose grit with a chainsaw sharpening wheel, but you will need to re-shape it periodically. Especially for wheels used to take down the depth rakers. They need to be trued back to flat periodically. The round wheels used for sharpening cutters need less touchup, but they do get out of shape after a lot of use and will need to be re-shaped.
