Firewood processor project.

   / Firewood processor project.
  • Thread Starter
#73  
It's a clean machine. Great!
 
   / Firewood processor project.
  • Thread Starter
#74  
the limit switch seem to work fine. My plan is to use sensor switch.
 
   / Firewood processor project.
  • Thread Starter
#75  
I have some questions for you guys, again :confused:

What do you think the thickness of the wedge need to be ? I want a 4 and 6 way wedge. Do you think 3/4 for the vertical wedge and 1/2 for the
horizontal blade is enough? I like this design:

View attachment 598284View attachment 598285

All the wedge that I see on the commercial processor seem relatively "thin" ,Like 3/4 " max .

Also do you think that the splitting push plate need wear pad, like teflon or something else?
Or metal on metal is okay?

Thanks
 
   / Firewood processor project. #76  
I made my wedge of 20mm material.
 
   / Firewood processor project.
  • Thread Starter
#77  
Ok ,I will go with 3/4" inch and we will see. the thing that worries me is how to sharpen the blade...
 
   / Firewood processor project. #80  
Easiest way to sharpen the wedge is turn the metal up on it edge and torch it toward the wide part. I use my home made track torch and clamp the steel plate to the end of my table with the narrow edge turned up. Set the torch on a angle i want and then just cut. I mark a line where I want the flame to exit the plate and just watch the flame. 5min with a grinder to clean it up and its a knife edge. 1227141106a.jpg1227141106.jpg
 

Attachments

  • 1227141102.jpg
    1227141102.jpg
    839.6 KB · Views: 152

Tractor & Equipment Auctions

2012 LINDE H80 FORKLIFT (INOPERABLE) (A50854)
2012 LINDE H80...
2018 John Deere 60G Excavator (A50490)
2018 John Deere...
2014 Nissan Maxima (A50324)
2014 Nissan Maxima...
1969 JOHNSON J25 GOOSENECK TRAILER (A51222)
1969 JOHNSON J25...
CATERPILLAR 12" BACKHOE BUCKET (A51242)
CATERPILLAR 12"...
2018 John Deere 1445 72in Front Mower (A48082)
2018 John Deere...
 
Top