Front weight setup

   / Front weight setup #1  

Anonymous Poster

Epic Contributor
Joined
Sep 27, 2005
Messages
29,678
Ok, I finally found the right disk. This is what I came up with for a weight system. I'm lucky because I work in an area where we have a fab shop and was able to get the supplies. However any welding or fab shop could make this up pretty quick I would think. The weights are from Wal-Mart and cost 10 bucks each and weigh 25#. I think this will be a nice system because they are easy to install and the weights can be used for other things. I have used them on my back blade for example.
 

Attachments

  • 285931-Mvc-002l.jpg
    285931-Mvc-002l.jpg
    66.6 KB · Views: 892
   / Front weight setup #2  
DetroitMike:

Woooohooo found the disk...Hey that is nice looking and put together well...I like it.. /forums/images/graemlins/grin.gif

Whiskey
 
   / Front weight setup
  • Thread Starter
#3  
Where does the dog attach--or is he still eating pizza?
 
   / Front weight setup
  • Thread Starter
#5  
Both set ups look great. As an engineer, a diagonal support bracket going upward that helps support the weight might be good. I don't know if it is necessary--I guess it depends on the strength of the welds.
 
   / Front weight setup
  • Thread Starter
#6  
Inspector,

I saw your setup a while back and liked it. I looked for the rectangle ones too but had no luck.
 

Tractor & Equipment Auctions

2019 Doosan DX225LC-5 Excavator (RIDE AND DRIVE) (VERY NICE) (A50774)
2019 Doosan...
2015 JOHN DEERE 5100M TRACTOR (A51243)
2015 JOHN DEERE...
2021 CATERPILLAR 317 EXCAVATOR (A51242)
2021 CATERPILLAR...
2018 INTERNATIONAL 4400 SBA 4X2 SERVICE TRUCK (A51406)
2018 INTERNATIONAL...
2024 WABASH STEP DECK TRAILER (A51222)
2024 WABASH STEP...
Knapheide Service Body with Liftgate (A49461)
Knapheide Service...
 
Top