Front weight setup

   / Front weight setup #1  

Anonymous Poster

Epic Contributor
Joined
Sep 27, 2005
Messages
29,678
Ok, I finally found the right disk. This is what I came up with for a weight system. I'm lucky because I work in an area where we have a fab shop and was able to get the supplies. However any welding or fab shop could make this up pretty quick I would think. The weights are from Wal-Mart and cost 10 bucks each and weigh 25#. I think this will be a nice system because they are easy to install and the weights can be used for other things. I have used them on my back blade for example.
 

Attachments

  • 285931-Mvc-002l.jpg
    285931-Mvc-002l.jpg
    66.6 KB · Views: 892
   / Front weight setup #2  
DetroitMike:

Woooohooo found the disk...Hey that is nice looking and put together well...I like it.. /forums/images/graemlins/grin.gif

Whiskey
 
   / Front weight setup
  • Thread Starter
#3  
Where does the dog attach--or is he still eating pizza?
 
   / Front weight setup
  • Thread Starter
#5  
Both set ups look great. As an engineer, a diagonal support bracket going upward that helps support the weight might be good. I don't know if it is necessary--I guess it depends on the strength of the welds.
 
   / Front weight setup
  • Thread Starter
#6  
Inspector,

I saw your setup a while back and liked it. I looked for the rectangle ones too but had no luck.
 

Tractor & Equipment Auctions

2017 DITCH WITCH RT30 (A51243)
2017 DITCH WITCH...
SHOP MADE PROPANE TRAILER (A50854)
SHOP MADE PROPANE...
2011 L3 GENERATOR SET (A51222)
2011 L3 GENERATOR...
2008 CATERPILLAR 320D L (A50854)
2008 CATERPILLAR...
2017 TRAILSTAR END DUMP TRAILER (A50854)
2017 TRAILSTAR END...
JOHN DEERE 450H CRAWLER DOZER (A51406)
JOHN DEERE 450H...
 
Top